# Descale

**URL:** <https://community.anovaculinary.com/t/descale/32604>\
**Category:** Anova Precision® Oven\
**Created:** [December 7, 2023, 5:01pm UTC](https://community.anovaculinary.com/t/descale/32604 "2023-12-07T17:01:02Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Barry](https://avatars.discourse-cdn.com/v4/letter/b/958977/32.png) [@Barry](https://community.anovaculinary.com/u/Barry)\
**Post date:** [December 7, 2023, 5:01pm UTC](https://community.anovaculinary.com/t/descale/32604/1 "2023-12-07T17:01:02Z")

</div>

I have descaled my Anova Oven, and after unplugging and plugging back in the Descale is still showing up on the handle. My firmware is up to date.  
Any ideas about this would be appreciated.

---

<div class="post-metadata">

**Author:** ![Barry](https://avatars.discourse-cdn.com/v4/letter/b/958977/32.png) [@Barry](https://community.anovaculinary.com/u/Barry)\
**Post date:** [December 7, 2023, 7:33pm UTC](https://community.anovaculinary.com/t/descale/32604/2 "2023-12-07T19:33:46Z")

</div>

I have resolved this problem

---

<div class="post-metadata">

**Author:** ![raymondchan](https://avatars.discourse-cdn.com/v4/letter/r/c6cbf5/32.png) [@raymondchan](https://community.anovaculinary.com/u/raymondchan)\
**Post date:** [October 21, 2024, 1:09pm UTC](https://community.anovaculinary.com/t/descale/32604/3 "2024-10-21T13:09:07Z")

</div>

Hi, Barry,

May I know how you resolved the issue? I encountered the same issue.

Regards,

Raymond